2′ × 6′ Pacific Shoring Lightweight Corrugated Aluminum Shield

The 2' x 6' Pacific Shoring Lightweight Corrugated Aluminum Shoring Shield is a lightweight, backhoe-liftable protective system designed for light-duty utility excavation work. Its 2-foot height and 6-foot panel length provide ample longitudinal coverage for smaller trenches while maintaining a compact shield configuration.

Built with horizontal corrugated aluminum sheeting and vertical shoring rails, this shield is available in hydraulic or pinned static configurations. It can also be used with Pacific Shoring's optional wheel kit when assembled according to the manufacturer's static-mode requirements.

Key Features

2' x 6' Shield Specifications

*Estimated weights are calculated as one-half of the manufacturer's published 4' x 6' light-duty rail shield weights (267 lbs hydraulic and 250 lbs static). Pacific Shoring describes 2-foot-high shield weights as approximately half those of corresponding 4-foot-high shields. Actual assembled weights should be confirmed before ordering or lifting.

A25, B45, and C60 represent the manufacturer's tabulated soil pressure assumptions. C60 is not an OSHA Appendix A soil classification. The manufacturer does not provide a C80 depth rating for this shield in the referenced selection table.

Ideal Applications

The 2' x 6' lightweight corrugated aluminum shield is intended for light-duty utility work where a low-profile shield configuration is beneficial.

• Localized water and sewer utility repairs
• Utility service connections and tie-ins
• Underground utility exposure, inspection, and maintenance
• Short utility trench sections requiring additional lengthwise coverage
• Projects where lightweight equipment handling is important
• Appropriate static-mode work using an optional wheel kit

The 2-foot shield height does not, by itself, determine an allowable excavation depth or application. Suitability depends on excavation geometry, soil conditions, shield configuration, and the manufacturer's tabulated data. The contractor's competent person must determine whether the selected system is appropriate for the work.

Hydraulic and Static Configurations

Optional Wheel Kit

Pacific Shoring's optional wheel kit allows a properly configured static shield assembly to be repositioned along the trench. This can be useful where the work progresses along a utility alignment and the wheel-kit configuration is appropriate for the excavation.

The wheel kit must be selected and assembled using the manufacturer's requirements for trench width, receiver length, crossbar material, and number of stacked shields.

• Wheel-kit use is limited to static-mode shields.
• Crossbars must be selected according to the manufacturer's wheel-kit tables and pinned to the wheel kit.
• Shield connections must be secured at all four corners.
• Stacked shields must be pinned together at all four corners.
• Maximum combined shield weight attached to the wheel kit: 1,380 lbs.

Trench Width and End Sheeting

The Pacific Shoring light corrugated shield system has manufacturer-stated allowable trench widths of 2 to 10 feet without end sheeting, and 2 to 7 feet with end sheeting, subject to the specific configuration.

Optional end sheeting uses telescoping brackets and requires either a hydraulic configuration with standard 2-inch cylinders pressurized to 1,000 psi, or a static four-sided configuration with sheeting on both ends.

End sheeting is not included as a standard feature of the 2' x 6' shield. Confirm component compatibility, sheeting material, and applicable restrictions before use.

Manufacturer Tabulated Data and Safety

The manufacturer's tabulated data governs the allowable use of this shield. The data references OSHA 29 CFR 1926 Subpart P and includes requirements for soil classification, trench width, allowable depth, surcharge loads, shield configuration, stacking, and optional accessories.